Power Supply

This is a Power Supply Unit (PSU) 20VDC 1.2 amps for the GTU MKIII.

This is a Power Supply Unit (PSU) for the GTU MKII for powering the MK2 GTU when there is no satellite signal in a system (DTT only).

A 18 volt Power Supply suitable for use in powering any active Splitter or Combiner when an external injected power source is not present or available. Weight 0.225kg

Product Features Universal AC input / Full range(up to 305VAC} Built-in active PFC function High efficiency up to 95% Fanless design, cooling by free air convection -55~+65oC wide operating range...

Dual switch Mode power supplies with individual IEC inputs of 90 to 264V AC and 12V DC outputs. The unit is supplied with a female 16 pin molex connector configured for use with ETL fibre components...

Model PSU05F20-9704 Switch Mode Power Supply with input range of 96 to 264V (AC) with fixed 5V output voltage and 4 A max permissible load. The unit is supplied with IEC cable at the

Switch Mode power supply with input of 90 to 264V AC and 12V DC output. The unit is supplied with IEC cable at the mains end and soldered pins at the DC end. Maximum current rating is 1.25A.

Dual switch Mode power supplies with individual IEC inputs of 90 to 264V AC and 12V DC outputs. The unit is supplied with a female 16 pin molex connector configured for dual redundancy when used with...

Highly efficient outdoor ready IP65 rated fixed 24V power supply unit. Fitted with Lemo Connector FGL.1K.302.CLLK75Z for DCIntended for use with ETL’s outdoor units e.g. model SRY-TR-L1-931 <

IP65 rated weatherproof 12V power supply. Key Features: - Two IP65 rated power units & connectors. - Removable cover for hot swap in case of failure. For use with ETL's St

Single unit IP65 rated weatherproof 12V power supply for use with StingRay RF Over Fibre ODU modules.   Parameter Specification Comments