Cables and Connectors

 KEY SPECIFICATIONSBandK-BandFrequency17.7 - 21.2 GHzProduct FamilyPower SplitterRF SPECIFICATIONSInput VSWR≤ 1.5 : 1Ins

A DC power cable that can be connected to the AC-to-DC power kit (U8ACC-00002-0) or AC-to-DC power kit (U8ACC-00044-0). It overrides the remote power trigger (ACC) function.

Kymeta U8ACC-00070-0 CABLE, POWER OSPREY U8

Kymeta U8ACC-00069-0 CABLE, OSPREY ETHERNET, 25 FT

An extension LMR cable with a male N type connector for the BUC and a female N type connector outside of the Hawk u8 ODU shroud. Connect this short cable to a longer coaxial cable connected to the TX...

An LMR-195 cable that connects the BUC to the communications module’s TX out port. The cable has standard N-type connectors at each end.

An LMR-195 cable that connects the LNB to the antenna RX IN port. The cable requires a right-angle N-type connector at the antenna end to maintain the low profile of the antenna without sharp or...

A cable that connects the communication module and BUC. This cable provides power to the BUC and communication to set attenuation, mute, and read output power.

A shielded Ethernet cable that provides power and control to the fan panel. This cable cannot be replaced with a standard Ethernet cable. Disconnect this cable at the connection halfway between the...

An outdoor rated RJ 45 Ethernet jumper cable with a male connection on one end and a female connection on the other. Refer to Kymeta u8 cable replacement instructions (700-00144-000) for more...

ETL’s AP series of cable assemblies are designed for general purpose laboratory and equipment applications where high performance, flexibility and low loss are key features. Connectors are SMA Male,...

ETL’s AP series of cable assemblies are designed for general purpose laboratory and equipment applications where high performance, flexibility and low loss are key features. Connectors are N-type...