Teledyne Encryption P2MP Dual IF/L-Band Satellite Modem

Overview

The QFlex-400™ Encryption P2MP modem is pre- configured to provide only the features required for use as a remote modem in a Q-NET™ point-to- multipoint IP system utilising a QMultiFlex-400™ hub. This makes it easy to purchase exactly what you need.
The modem is fitted with the standard QFlex-400 modem software and so can also operate point- to-point. Additional features for point-to-point operation, as per the
The QFlex-400E P2MP modem supports the most powerful bandwidth-saving technology available. There is a choice of DVB-S2X or FastLink™ low- latency LDPC for both the outbound and inbound carriers. DVB-S2X, is 20% to 60% more bandwidth efficient than its predecessor, DVB-S2. Bandwidth-saving IP features include variable coding and modulation (VCM), adaptive coding and modulation (ACM) and TCP acceleration. Data for the remote modem can be filtered from the shared outbound using Virtual LAN ID, stream ID, IP address, DSCP, etc.

Market and Applications

• Military and Government secure networks
• Maritime, oil & gas communications
• Comms-on-the-move (COTM) networks
• IP trunking/backhaul & cellular backhaul
• Corporate/enterprise networking
• Government universal service obligation networks
• Broadcast

Features 

• Dual IF/L-band operation
• Encrypts all IP traffic using AES 256 Encryption as standard
• Rx data rates to 345Mbps; Tx to 100Mbps
• Point-to-point & point-to-multipoint operation
• XStream IP™ advanced IP optimization suite, including TCP Acceleration, header & payload compression, dynamic routing, traffic shaping, jitter reduction & ACM
• Choice of DVB-S2/S2X or FastLink™ LDPC outbounds/inbounds
• Optimized spectral roll-offs, including 5%
• LinkGuard™ signal-under-carrier interference detection
• Built-in spectrum & constellation monitors
• DVB Carrier ID (to DVB-CID standard)
• Q-NET™ Navigator network control app
• Software Defined Network support: vendor- independent network device control using standard commands (supports OpenFlow)

Why QMultiFlex-400?
Historically, networks required separate boxes for modulators, demodulators, IP optimisers, Ethernet switches, routers, packet encapsulators, spectrum analysers, oscilloscopes, redundancy controllers.

The QMultiFlex-400 replaces all of these, at a significant cost savings even before considering the cost of spares, training and maintenance for all those individual boxes. And these savings can be multiplied as you scale your network.