Global Invacom

The Global Professional GPS Passive 4 way splitter has been designed to allow the signals from a GPS Antenna to be shared between four receivers. The unit could also be used as a combiner. The unit...

The Global Professional GPS Passive 8 way splitter has been designed to allow the signals from a GPS Antenna to be shared between eight receivers. The unit could also be used as a combiner. The unit...

The Global Professional GPS Active 2 way Splitter has been designed to allow the signal from a GPS antenna to be shared between two receivers. The unit is configured to insert a DC voltage to the...

The Global Professional GPS Active 8 way Splitter has been designed to allow the signal from a GPS antenna to be shared between eight receivers. The unit is configured to insert a DC voltage to the...

The Global Professional 70MHz to L Band Frequency Converter enables monitoring of a 70 or 140 MHz bus of an uplink and downlink stations using an inexpensive L band receiver. The unit works as an...

The Global Professional UHF to L Band upconverter enables reception of signals in the UHF range on a L Band input receiver. The unit works as an upconverter, but also allows for downconversion in...

The Global High Stability 70MHz to L Band Upconverter enables monitoring of 70 or 140 MHz Bus of uplink and downlink stations using an inexpensive L Band input receiver. In addition to upconversion,...

Our Small Form-Factor Pluggable (SFP) Gigabit Interface Converter is a hot-swappable input/output device plugs into a Gigabit Ethernet port or slot.   The SFP device supports up to 1 GB...

The Sat-Light/Platinum WDM PL7635 multiplexes and de-multiplexes 1310 nm and 1550 nm optical wavelengths on one single optical fibre thus enabling transmission of two different RF signals over a...

The L-Band RF splitter PL7622 is a high performance passive 2 way L-Band RF splitter/combiner. It supports dual port DC passing capabilities, needed for a redundant Low Noise Block (LNB) powering...

The 5-10MHz/L-Band diplexer PL7641 is a passive unit used to separate or combine 5-10MHz reference signals to an L-Band signal. It reduces cable connector failures and greatly improves cable...