ETI Snow Switch SC-40C

The ETI SC–40C snow and ice melting satellite contactor answers the need for cost effective modular snow melting heater control. One or more SC–40Cs, when used with an APS–4C control panel acting as the master control, allow for modular snow melting system design. There is no limit to the number of SC–40Cs that can be interfaced in a single system. This approach reduces front end design, hardware, and installation costs while providing a number of useful features that would be otherwise too expensive and complex to implement.

The SC–40C provides Ground-Fault Equipment Protection (GFEP) as required by the national electrical codes. Upon sensing a ground-fault condition, the SC–40C inhibits operation of its contactor until manually reset. Circuits without a ground fault continue to operate normally, thus partitioning defective heating cables.

The adjustable hold-on timer continues heater operation on each SC–40C for up to 10 hours after snow stops to ensure complete melting and to compensate for differences between zones. The optional RCU–4 remote control unit can be located where system operation can be conveniently observed. It duplicates many of the controls and indicators on the SC–40C front panel.

Each SC–40C provides a complete energy management computer (EMC) interface. This feature provides remote access for advanced applications requiring remote or zone control along with remote annunciation. Each SC–40C maintains communication to and from the APS–4C using a 3-wire cable. Thus, the APS–4C alarms ground faults occurring anywhere in the system. This feature inserts a short time delay between the operation of each contactor, thus improving power quality by limiting the inrush current.

The RCU–4 remote control unit supplied permits overriding zone control in applications requiring the capability.

FEATURES & BENEFITS

• Automatic snow and ice melting control minimizes operating costs
• ETI PN 22477: 208-240 VAC, 50 amp max.resistive

ETI PN 22478: 277 VAC, 40 amp max. resistive

ETI PN 22480: 277/480, 50 amp max. resistive

ETI PN 22481: 600 VAC, 50 amp max. resistive

UL Listed for Temperature Regulating Equipment

• Adjustable Hold-On timer continues heater operation after snow and ice stop to ensure complete melting
• Automatic and manual-override operator controls forG changing environmental conditions
• Optional remote control operation for added convenience
• Integral 30mA of Ground Fault Equipment Protection (G GFEP) Weather-resistant NEMA 3 R enclosure